







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in San Gabriel, CA: What It Takes and What It Costs
Concrete driveways and concrete work in San Gabriel, CA typically cost $4,500 – $12,000 for a full driveway installation, and most residential pours wrap up in 3 – 5 days once we break ground. That figure covers demo, forming, a proper base, pour, finish, and curing at a standard two-car width. Call (844) 797-7958 and we’ll walk your apron and approach before you commit to a number.
How a Concrete Driveway Job Actually Runs, Stage by Stage

We don’t hand you a start date and disappear. Here’s the real sequence, so you know what each day looks like and where your decisions land.
Stage 1: Site walk and layout (day 1, 45 – 90 minutes)
We measure the apron, check the slope away from the garage, and look at what’s under the existing surface – old slab, gravel, or packed San Gabriel Valley soil. This is where you decide width (single 10 ft or double 16 – 20 ft), finished look, and whether the new slab ties into the curb or stops short for a decorative border. The number you get is the number you pay.
Stage 2: Demolition and haul-off (days 1 – 2)
Old concrete comes out with a breaker and skid-steer, then loads go to the transfer station. On a 1920s San Gabriel bungalow lot, that often means working around mature roots and a garage that sits close to the property line. Expect one full day for demo on a typical 400 sq ft driveway, longer if there’s a second slab or a defunct footing.
Stage 3: Base prep and grading (day 2, half to full day)
We excavate 4 – 6 inches, compact class II base in lifts, and set the slope so water runs to the street instead of pooling against the garage. This step is where a cheap job gets exposed later. Skip it and you’re paying for cracks in three winters.
Stage 4: Forming, rebar, and pour (days 3 – 4)
Forms go up, #3 or #4 rebar at 18 – 24 inch on center gets tied on chairs (not laid flat on the dirt), and we pour at 4 inches – 5 inches if you park something heavy. You pick the finish before the truck arrives: broom, exposed aggregate, or a saw-cut pattern. Most driveways here run 4 – 6 yards of 3,000 – 4,000 psi mix.
Stage 5: Finish, control joints, and cure (days 4 – 5, then 7 days off the slab)
We cut control joints within 12 – 24 hours so the concrete cracks where we tell it to, apply cure and seal, and give you a timeline for driving on it. Typically 7 days before you park on it, 30 days before you wash it with anything harsh.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Concrete Options You’ll Be Choosing Between
There isn’t one right answer here. There’s the answer that fits your lot, your budget, and how the finish reads against a 1930s stucco facade.
- Standard broom-finished concrete – the workhorse. Grippy, hides dirt, holds up to Valley sun. Best value for a functional driveway; runs at the lower end of the $4,500 – $12,000 range.
- Exposed aggregate – pebble surface, more texture, more character. Adds roughly 10 – 20% to material and labor; suits a Spanish Colonial façade where a plain gray slab looks too modern.
- Saw-cut or scored pattern – clean grid lines that mimic pavers or tile without the paver price. Good middle ground when design review is looking at visible-from-street surfaces.
- 4-inch vs 5-inch slab – 4 inch is standard for cars; 5 inch with heavier rebar is the call if you park a truck, RV, or trailer. The upgrade is small money up front and cheap insurance.
- Integral color – pigment mixed into the pour rather than painted on top. More expensive than gray but it doesn’t chip off, and it helps a new driveway sit naturally next to older stucco.
If your project also includes the front walkway or a rear patio, the wider scope lives on our Driveway & Pavers in San Gabriel page. This page stays on the concrete driveway and concrete flatwork itself.
What Concrete Driveways & Concrete Work Costs in San Gabriel, CA

For a standard residential driveway, expect to land between $4,500 and $12,000. A driveway replacement that includes demo and haul-off of the old slab usually runs $5,000 to $14,000. Here’s what moves a job north or south inside those bands:
- Square footage and width – a single-car pad at 250 sq ft is a different job from a 500 sq ft double with a turnaround.
- Existing condition – thick old slabs, hidden footings, or tree roots under the pour add demo time and base repair.
- Access – tight San Gabriel lots with a narrow gate mean hand-hauling material. That labor shows up in the bid.
- Finish grade – broom is the baseline; exposed aggregate, integral color, and decorative borders each add.
- Drainage and grading – if we have to add a channel drain or regrade to keep water out of the garage, that’s real scope.
Every written estimate lists what’s included: demo, haul-off, base, rebar, pour, finish, joints, and seal. What’s not included – permits where the city requires them, unforeseen utility relocation, or landscaping repair – gets spelled out separately, never buried. And you get a free on-site estimate and design consult, so the number is built from your actual lot, not a phone guess.
See the difference
Before
After
Before
After
Before
AfterWhat San Gabriel Homes Specifically Do to This Job
San Gabriel is not a blank-slate suburb, and that shapes every concrete pour we touch. The core of the city is 1920s – 1940s Spanish Colonial Revival and California bungalow stock on small lots, and many of those driveways were poured decades ago at 3 – 4 inches with no rebar. They don’t crack because concrete gets old; they crack because the base was never right and the Valley’s hot, dry summers and the occasional Santa Ana wind event work the slab hard. We see the same pattern near the Mission District and along the blocks around the 91776 and 91775 ZIPs: sun-baked aprons with hairline cracks that spider into full breaks after a wet winter.
The bigger local wrinkle is the city’s design-review culture. On a Mission District property, a new driveway apron visible from the street can trip historic-preservation review, and inspectors are strict about matching the character of a Craftsman or Spanish Colonial facade. We plan the finish color and surface texture with that in mind before the truck rolls. We also tie exterior work into the wider home when it makes sense – homeowners often pair this with Door Installation in San Gabriel to get the entry and the approach looking like one project, and ADU projects frequently need their own parking pads alongside ADU Site Prep & Utilities in San Gabriel. We cover all of San Gabriel and the neighboring blocks in East San Gabriel and San Marino when the job fits.
Serving San Gabriel, CA – Our Local Coverage Area
We serve San Gabriel and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Concrete Driveways & Concrete Work in San Gabriel

A standard residential driveway runs 3 – 5 working days from demo to final joint cut, then 7 days before you park on it. Larger projects with extensive demo or a lot of hand-hauling push toward the longer end. Call (844) 797-7958 and we’ll give you a specific schedule once we see the site.
Most straightforward driveway replacements don’t require a building permit, but work that touches the public right-of-way near the curb, adds a new approach, or falls under historic review may. We flag the ones that do before any work starts, so there are no surprises. Call (844) 797-7958 to talk through your specific lot.
Usually, yes. Standard driveway pours don’t touch plumbing, gas, or the garage foundation unless the existing slab is sitting on top of a buried line or a hidden footing. We locate utilities and inspect for footings during demo before we finalize the base prep. Call (844) 797-7958 for a site check.
Installation runs $4,500 – $12,000, and a full replacement runs $5,000 – $14,000. Finish, access, and existing slab condition are the three biggest factors. Call (844) 797-7958 for a written line-item quote – the estimate and design consult are free.
Every concrete driveway project is backed by our 730-Day Done Right Promise – if it’s not done right, we make it right. Our technicians have up to 12 years of experience, and the local pro we connect you with is licensed and insured as California requires. Call (844) 797-7958 to schedule your free estimate.
Get Your Concrete Driveway Estimate
If your San Gabriel driveway is cracked, sunken, or just past its years, the next step is a free on-site estimate. We’ll walk the lot, talk through the finish options, and put a written line-item number in your hands. Call (844) 797-7958 and a live person picks up, day or night. Our Driveway & Pavers team handles the wider scope if the project grows.
Written by the team at Groundwork Construction Co.












