







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Sierra Madre, CA: What It Takes and What It Costs
Most door installation jobs in Sierra Madre run between $450 and $2,800 per door, depending on whether it’s an interior swing door, a prehung exterior entry, or a heavy shop door on a canyon lot. A single interior door is often done in one visit; exterior entries and oversized workshop doors take longer because of framing, flashing, and hillside movement. Call (844) 797-7958 for a free on-site estimate before you commit to anything.
How our door installation process actually runs, stage by stage

Door work looks simple from the driveway. It isn’t, especially on the older hillside properties we see off Sierra Madre Boulevard. Here’s the real sequence, and where you make decisions.
1. Walkthrough and measurement (day 1, about 60 – 90 minutes). We check the rough opening, the plumb and level of the existing frame, and whether the header is carrying load. On older homes that means looking at the framing behind the trim, because a Craftsman bungalow from the 1920s rarely has a square opening underneath. You decide: replace just the slab, or the full prehung unit with a new frame. That single choice swings the price more than any other.
2. Written estimate and material selection (2 – 4 days after the walkthrough). You get a line-item quote, not a lump sum. We talk through door material, finish, hardware, and whether an oversized workshop or garage-adjacent door needs a heavier-duty hinge and closer setup. You lock the spec here, and the number you see is the number you pay.
3. Demo and prep (day of install, 1 – 3 hours). Old door and trim come out, the opening gets cleaned, and we check for rot or seepage at the sill. On canyon-edge homes, this is where we sometimes find the drainage issue the last remodel covered up. If the framing is soft, we stop and tell you before adding cost.
4. Hanging, shimming, and sealing (3 – 6 hours). The new unit goes in, gets shimmed plumb, and the exterior gets flashed and sealed against our winter rain. We test the swing, the latch, and the weather seal. This is the stage most one-trip operations rush. We don’t.
5. Final check and walkthrough (under an hour). You operate the door yourself, we confirm the hardware and finish, and we hand over the written guarantee. Most single-door jobs finish in one visit; exterior and oversized doors may run a second trip for trim and paint.
Our technicians have up to 12 years of experience, and every one is background-checked and uniformed. Work is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The door options you’ll be choosing between
The trade-offs matter more than the brand name on the sticker. Here’s what actually comes up in Sierra Madre.
- Solid wood vs. engineered wood: Solid wood gives you the weight and feel that fits the Craftsman and Spanish Colonial stock here, but it moves with our dry summers. Engineered cores hold their shape better and cost less; the trade-off is a lighter feel in the hand.
- Steel and fiberglass exteriors: For wildfire-defensible assemblies on foothill lots, a steel or fiberglass entry with the right rating is the practical pick. They resist ember exposure better than wood and need less upkeep. You give up some of the vintage look.
- Prehung vs. slab replacement: A prehung unit with a new frame is the honest choice when the old frame is out of square. A slab swap only works if the existing frame is sound, and it’s cheaper and faster when it’s the right call.
- Heavy-duty shop and oversized doors: Detached workshops and oversized openings on acreage properties need heavier hinges, a commercial-grade closer, and a reinforced jamb. It costs more up front and saves you a re-hang in two years.
- Hardware and finish: Entry sets, deadbolts that meet current code, and a proper weather seal are line items, not afterthoughts. Finish grade (paint vs. stain) affects maintenance over the next decade.
What door installation costs in Sierra Madre, CA

Plan on $450 to $2,800 per door installed, with the typical interior door landing near the low end and a fire-rated or heavy-duty exterior entry toward the top. These ranges hold across ZIP codes 91024 and 91025.
| Line item | Typical range |
|---|---|
| Interior swing door, installed | $450 – $1,100 |
| Exterior entry door, prehung, installed | $1,200 – $2,800 |
| Heavy-duty shop or oversized door | $1,800 – $4,500 |
| Slab replacement only | $300 – $900 |
| Hardware and finish | $150 – $600 |
Four things push a job toward the high end: the size and weight of the door, the condition of the existing frame and framing, whether the opening needs reframing or new flashing, and the material and fire rating you select. Access on a steep hillside lot adds time too.
A written estimate covers the door unit, removal and disposal, framing prep, shimming, flashing, hardware, and finish sealing. It typically does not cover structural repair if we uncover rot or seepage, or painting beyond the installed unit. We price those separately and only after you approve. Financing at 0% for 18 months is available, and projects over $10,000 get $1,000 off.
See the difference
Before
After
Before
After
Before
AfterWhat Sierra Madre homes specifically do to this job
The housing stock here changes the work. Near the downtown core you have Craftsman bungalows and Spanish Colonial Revival homes with 90-year-old openings that are rarely square. Up the slopes, mid-century ranches and custom hillside builds sit on foundations and drainage that move with the terrain, so a door that stuck last summer may swing free by winter. The canyon neighborhoods off Sierra Madre Boulevard often hold older additions built without permits, and we routinely uncover framing and seepage problems that need fixing before a new door goes in. Add the Santa Ana wind and wildfire-defensibility requirements, and fire-rated exterior assembles aren’t optional on many foothill lots. Because Sierra Madre is a small preservationist town, exterior door changes on older homes can trigger a design review, so we confirm what’s required before we order anything. If the door is part of a broader scope, see our Windows & Doors in Sierra Madre page, and homeowners often pair this with Cabinets & Countertops in Sierra Madre during a kitchen update or with a Garage Conversion ADU in Sierra Madre when converting a shop or garage. We cover the whole of Sierra Madre along with nearby East San Gabriel, San Marino, San Gabriel, and Altadena.
Serving Sierra Madre, CA – Our Local Coverage Area
We serve Sierra Madre and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: Door Installation in Sierra Madre

A single interior door is usually done in one visit of three to six hours. Exterior entries and oversized shop doors may run a second trip for trim and paint. Call (844) 797-7958 for an exact timeline.
Like-for-like replacements often don’t need a permit; new openings, structural changes, or fire-rated egress work usually do. We confirm what applies before we start and pull what’s required. Call (844) 797-7958 and we’ll walk you through it.
In most cases yes, a direct replacement reuses the existing opening. If the frame is out of square or the header needs work, we tell you before adding anything to the price. Call (844) 797-7958 for a free estimate.
Interior doors run $450 – $1,100 installed, exterior entries $1,200 – $2,800, and heavy-duty shop doors $1,800 – $4,500. Call (844) 797-7958 for an exact quote. Estimates are free.
Every door we install is backed by the 730-Day Done Right Promise: if it’s not done right, we make it right. Our Windows & Doors service carries the same written guarantee.
Get a free door installation estimate in Sierra Madre
Ready to price the job? Call (844) 797-7958 to schedule a free on-site estimate. We’ll measure the opening, talk through material and hardware, and hand you a written line-item quote with no surprises. A live person answers around the clock, so you’ll get a real conversation, not a voicemail. Most jobs are completed in a single visit, backed in writing.
Written by the team at Groundwork Construction Co.












