







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
See the difference
Before
After
Before
After
Before
AfterConcrete Driveways & Concrete Work in Burbank, CA
Concrete driveway installation in Burbank typically runs $9 to $18 per square foot, and most residential driveways land between $6,500 and $18,000 depending on size, access, and whether you’re replacing or pouring fresh. Concrete work goes well beyond the driveway itself: patios, walkways, steps, retaining walls, and slab replacements all fall under the same trade, and getting one crew to handle all of it keeps the grades and finishes consistent. Groundwork Construction Co. of Burbank does concrete work across the city with upfront pricing and a written guarantee, and you can reach us at (844) 797-7958 to set up a free estimate.
Burbank sits on ground that moves. Much of the city rests on older alluvial soil and decomposed granite, and the flat valley floor holds a lot of clay that swells when it takes on winter rain and shrinks through the dry summer. That cycle is hard on concrete. A slab that was poured without proper base prep and control joints will crack, heave, and settle within a few seasons, and no amount of patching fixes a bad foundation pour. We plan for it on every job: compacted base, correct thickness, steel where it belongs, and joints cut at the right spacing for the slab’s size.
If you’re mapping out a larger exterior project, this work fits under our full Driveway & Pavers in Burbank service alongside pavers, and it pairs naturally with fence and hardscape upgrades. You can see how all of it comes together on our home page.
Key Takeaways
- Concrete driveway installation in Burbank runs roughly $9-$18 per square foot; a typical two-car driveway lands between $6,500 and $18,000.
- Burbank’s clay-heavy soil and wet-winter/dry-summer cycle make base prep and joint placement the two things that decide whether a slab lasts.
- Most residential pours take 2-4 days from demo to cure, weather permitting.
- Every job is covered by our 730-Day Done Right Promise, and calls are answered by a live person 24/7.

When You Need Concrete Driveways & Concrete Work
Concrete doesn’t usually fail all at once. It gives you warnings. Here’s what we see most often in Burbank, and what each one usually means.
- Spiderweb cracks spreading across the driveway. Hairline cracks in a properly jointed slab are normal. Cracks that branch out from a corner or run through the middle of a panel often point to a thin pour, missing control joints, or a base that wasn’t compacted. Once water gets in and freezes overnight in a Burbank cold snap, the crack widens every season.
- Sunken or heaved slabs. You feel a bump pulling into your own driveway, or water pools against the garage door instead of running to the street. That’s a sign the soil underneath has settled or swelled. In the older neighborhoods around Magnolia Park and Rancho, where homes date to the 1920s through the 1950s, we regularly find thin original slabs over native soil with no base at all.
- Crumbling, scaling surface. The top layer flakes off and leaves a rough, gravelly finish. Poor finishing during the original pour, deicing salt, or a mix that was too wet all cause it. Resurfacing can buy you a few years; a full replacement is the honest fix when the surface is failing across the whole slab.
- Cracked or tilted steps and walkways. Trip hazards are a liability, and Burbank’s hilly streets and stepped front entries make this common. We rebuild steps to current code with proper rise and run.
- New driveway, patio, or slab from scratch. Adding a widened driveway for a second vehicle, a backyard patio, an RV pad, or a shed foundation. If you’re putting up a Tuff Shed or similar structure, the slab underneath needs to be engineered and level or the building never sits right.
- Garage floor and interior slab work. Cracked, pitted garage floors, or converting a space that needs a fresh slab. We handle flatwork inside and out.
If your project also involves replacing a worn wooden fence or redoing the front of the house, that work can run on the same schedule so you’re not juggling three contractors. Our fence installation in Burbank and home additions and ADU work in Burbank pages show where concrete ties into bigger builds.
Our Concrete Driveways & Concrete Work Process
Good concrete is mostly invisible work. The pour is the short part. Here’s how we run a project from the first call to the final walkthrough.
- Free on-site estimate and design consult. We walk the property, measure, check the existing base, and talk through layout, thickness, finish, and drainage. You get a written, upfront price: the number you see is the number you pay. No surprise line items after the work starts.
- Permits and utility checks. Most driveway replacements in Burbank require a permit through the city’s building division, and we pull it. Before anyone cuts, we call for utility locating. A driveway that crosses a sewer lateral or gas line needs to be planned around, and Burbank’s older properties have plenty of both buried in unexpected places.
- Demo and haul-off. We break out the old slab, load it out, and dispose of it properly. That includes the base material, not just the surface, because a new pour over a failed base is money wasted.
- Base prep and grading. This is where a driveway earns its life span. We excavate to the right depth, bring in and compact a graded aggregate base, and set the slope so water runs away from the house and toward the street or a drainage feature. On Burbank’s clay soil, we pay close attention to grade and drainage so the slab isn’t sitting in a bowl.
- Forming, reinforcement, and pour. Forms go in square and level. Steel reinforcement goes in where the slab needs it. We pour at the right thickness (4 inches for standard driveways, 5-6 inches where heavier vehicles park) and finish to the surface you chose, from broom finish to exposed aggregate to stamped borders.
- Control joints, curing, and final walk. Joints get cut at the correct spacing so the concrete cracks where we tell it to, not where it wants to. We cure the slab properly, keep you off it while it sets, and walk the finished work with you before we call it done. If anything isn’t right, our 730-Day Done Right Promise backs it in writing.
Why the base work matters more than the pour
A lot of concrete problems we’re called out to fix started with someone skipping steps on the base. It’s the cheapest part of the job to do right and the most expensive to fix later. We’d rather spend an extra day on compaction and grading than hand you a slab that fails in three years. That’s the piece homeowners can’t see when the job’s done, which is exactly why it matters.

Concrete Driveways & Concrete Work Pricing in Burbank
Concrete pricing in Burbank runs a bit higher than in the surrounding valleys because of access, permitting, and the base work our soil demands. Here are honest ranges so you can budget before you call. Every project gets a free on-site estimate with an upfront, written price.
| Project | Typical range in Burbank |
|---|---|
| Standard concrete driveway (2-car, 4″ pour) | $6,500 – $18,000 |
| Cost per square foot (installed) | $9 – $18 per sq ft |
| Driveway replacement (demo + haul-off included) | $8,500 – $22,000 |
| Concrete patio (200-400 sq ft) | $4,000 – $9,500 |
| Walkway or path | $1,800 – $6,000 |
| Concrete steps (per step, rebuilt to code) | $350 – $900 |
| Decorative finishes (stamped, exposed aggregate, colored) | Adds $3 – $8 per sq ft |
What moves the number up or down:
- Size and thickness. Square footage is the biggest driver. A wider driveway for a second vehicle or an RV pad raises the total, and thicker pours for heavy vehicles cost more in material.
- Access. A tight lot on a hillside street above Kenneth Road or a narrow driveway off a busy commercial block means more labor to move material and haul out debris. That’s real cost, and we’d rather show it upfront than surprise you later.
- Base conditions. If the existing base is solid and just needs a refresh, you save. If we’re excavating failed native clay and bringing in new base material, that’s added labor and material.
- Finish. A broom finish is the standard, most cost-effective surface. Stamped concrete, exposed aggregate, and colored finishes add per-square-foot cost but give a driveway a much more finished look.
- Drainage and grading. Sloping a driveway toward a proper drain or away from a low foundation takes planning and sometimes extra materials.
To make a larger project manageable, we offer 0% financing for 18 months and $1,000 off projects over $10,000. That applies whether you’re replacing a driveway or doing concrete work as part of a bigger exterior project. Call (844) 797-7958 for a free estimate and we’ll put real numbers on paper for your property.
Repair or replace?
It depends on what’s failing and how much of it. A handful of isolated cracks can be sealed and you’ll get more years out of the slab. But when a driveway has widespread cracking, settled panels, and a scaling surface all at once, patching is throwing money at a foundation problem. We’ll tell you straight which one you need, and we won’t push a replacement you don’t need. When a replacement is the right call, we’ll show you why.
How long does a concrete driveway last in Burbank?
A well-poured, properly based concrete driveway in Burbank should hold up for 25 to 30 years or more. The variables are base prep, thickness, reinforcement, joint placement, and drainage. Slabs that skipped those steps often start cracking and settling within 5 to 10 years. Our technicians have up to 12 years of experience working through exactly these conditions, and that experience is what keeps the timeline on the long end.
Concrete and the rest of your exterior
A driveway is usually part of a bigger front-of-house picture. Homeowners who replace concrete often pair it with new siding, a fresh entry, and a rebuilt porch. When a project expands like that, we bring in the same brand partnerships we use across our trades, from James Hardie siding to KraftMaid cabinetry on an interior finish. One contractor, one schedule, one written guarantee covering the whole job. You can see how a full-scope project comes together on our kitchen remodeling in Burbank and roofing in Burbank pages.
We also work with homeowners across the surrounding neighborhoods on matching concrete and hardscape projects, and those jobs follow the same standards whether they’re in Burbank or next door. If you’re coordinating across the area, our Glendale and North Hollywood teams run the same process.
FAQs – Concrete Driveways & Concrete Work
How much does a concrete driveway cost in Burbank?
A standard two-car concrete driveway in Burbank usually costs between $6,500 and $18,000, or roughly $9 to $18 per square foot installed. The final number depends on square footage, thickness, base conditions, access, and finish. Burbank pricing runs a little higher than the surrounding valleys because of clay soil that demands more base work and tighter access on some hillside lots. Call (844) 797-7958 for a free on-site estimate with an upfront price; estimates are free.
Do I need a permit to replace my driveway in Burbank?
In most cases, yes. Burbank requires a permit for driveway replacement and most significant flatwork, and the city checks things like setback from property lines, slope, and drainage. We pull the permit for you as part of the job, so you’re not standing in line at the building division. If your project touches the public right-of-way or a sidewalk apron, there may be additional approvals involved, and we’ll sort that out during the estimate.
How long does a concrete driveway take to install?
Most residential concrete driveways take 2 to 4 days from demolition to the finished pour, weather permitting. Your slab then needs several days to cure before you drive on it, typically about 7 days for full vehicle traffic and longer for heavy vehicles or cold weather. We’ll give you a realistic timeline upfront and tell you exactly when you can park on it. Same-day and rush scheduling is available for urgent repairs; call (844) 797-7958 and a live person will help you plan.
Is it cheaper to repair or replace my concrete driveway?
Repair is cheaper when the damage is isolated: a few cracks, a single settled panel, surface sealing. Replacement is the better value when the whole slab is cracking, settling, or scaling, because patching a failed foundation pour just prolongs the problem. As a rule of thumb, if repairs cost more than about 40 percent of a replacement, replace it. We’ll assess it honestly during the free estimate and tell you which one you actually need.
What kind of concrete finish should I choose for a Burbank driveway?
Broom finish is the most practical choice for a Burbank driveway. It grips well in the rain, costs less than decorative finishes, and hides tire marks and everyday wear. If you want a more finished look for a visible front driveway, stamped or exposed aggregate adds $3 to $8 per square foot and holds up well in our climate. We’ll walk you through samples during the design consult so you can see and feel the options before deciding.
Does Groundwork back its concrete work?
Yes. Every concrete project we do is covered by our 730-Day Done Right Promise: if it isn’t done right, we make it right. That’s one of the longest workmanship guarantees in residential construction, and it’s in writing. Our technicians are background-checked, arrive in uniform, and our calls are answered by a live person 24/7. If something needs attention after the job is finished, you call and talk to a human.
Can you do concrete work alongside other exterior projects?
Yes, and doing it in one schedule usually saves you money and time. Concrete, fencing, siding, and roofing all share the same exterior footprint, and coordinating them under one contractor means fewer scheduling conflicts and one point of accountability. When you bundle projects, the $1,000 off projects over $10,000 promotion may apply. Call (844) 797-7958 to talk through what you have in mind.
Get a Free Concrete Estimate in Burbank
Whether you’re replacing a failed driveway, pouring a new patio, rebuilding steps, or planning concrete work as part of a larger exterior project, we’ll give you a straight, upfront price and stand behind the work in writing. Call (844) 797-7958 today for a free project estimate and design consult. A live person answers around the clock, so you’ll talk to a real human, not a voicemail. Concrete done right the first time costs less than doing it twice, and that’s the only way we do it.
Written by the team at Groundwork Construction Co. of Burbank, serving Burbank.


