







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in La Crescenta-Montrose, CA: What It Takes and What It Costs
Door Installation in La Crescenta-Montrose runs $650 to $2,400 per exterior door fully installed, and most single-door projects wrap in one to two days. Interior doors land lower, usually $350 to $900 each depending on the slab and hardware. Storm-rated front, side, and patio entries that hold up to foothill wind and ember exposure push toward the top of that range because the door unit itself, the reinforcement, and the county inspection all carry real cost. Call (844) 797-7958 to schedule a free on-site estimate, and you’ll get a written line-item quote before anyone touches the frame.
How our door installation process actually runs, stage by stage

Most companies describe this job in one sentence. Here’s the real sequence so you know what you’re paying for and when you need to make a call.
Stage 1: Measure and site check (day 1, about 60 minutes)
We measure the rough opening, check the existing frame for rot, and look at how the door sits relative to the sloped grade. On hillside lots this is where we find out whether the threshold has been holding water. You decide the swing direction, the finish, and whether you want a screen or storm combination at this stage.
Stage 2: Material and spec confirmation (days 1 – 3)
You lock in the door unit, the hardware, and the deadbolt. Exterior doors are typically ordered rather than stocked, so lead time runs two to four weeks on most fiberglass and steel units. This is also when you decide on wind-load reinforcement and whether the frame needs sistering. James Hardie or a comparable composite surround gets chosen here if you’re replacing trim.
Stage 3: Demo and prep (day of install, 2 – 3 hours)
Old door and casing come out. We inspect the rough opening for rot, damaged framing, and water intrusion. On mid-century homes this step regularly turns up a soft sill or a header that needs reinforcing. You decide whether we replace the whole frame or patch it, and that choice is the single biggest swing in cost.
Stage 4: Set, shim, seal, and flash (day of install, 3 – 4 hours)
The new unit goes in plumb and square, gets shimmed, anchored, insulated, and flashed. Exterior sealant goes on after the flashing, not before. We test the swing and the latch against the strike plate before moving to trim. You don’t have to make any decisions here, but you should walk the door and check the reveal yourself.
Stage 5: Trim, hardware, and inspection (same day to day 2)
Casing goes on, hardware gets installed, and the inspection gets scheduled if the job triggered a permit. We hand over the manufacturer’s wind-rating documentation and the written warranty. Then we walk the door with you and confirm the seal, the swing, and the lock line up.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll be choosing between for your door installation
- Fiberglass vs. steel vs. wood exterior doors. Fiberglass holds up best in foothill heat and won’t dent like steel or warp like wood. Steel is cheaper but dents and rusts at the seams. Wood looks great and takes a beating on maintenance.
- Impact-rated vs. standard units. Impact-rated doors are worth the 20% to 30% premium here because ember and wind exposure is real. Standard units rely on reinforcement and weatherstripping alone.
- Reinforced frame vs. standard frame. A reinforced steel or heavy-gauge frame can add $300 to $700 and is what allows a door to survive a wind gust that would rack a standard frame. Worth it on any door facing the windward side.
- Slab replacement vs. full unit replacement. Slab swaps save $400 to $900 but only work when the existing frame is sound. Full units include new jambs, threshold, and flashing and last far longer.
- Hardware and deadbolts. A standard passage set runs $60 to $150. A commercial-grade deadbolt with a reinforced strike plate runs $150 to $350 and is what stops a door from kicking in.
- Interior slab options. Hollow-core is light and cheap, solid-core blocks sound and adds about $80 to $200 per door. KraftMaid and Wellborn make door-and-trim packages that pair well with a kitchen or cabinet refresh if you’re doing both.
What Door Installation costs in La Crescenta-Montrose, CA

Door Installation in La Crescenta-Montrose runs $650 to $2,400 per exterior door and $350 to $900 per interior door, installed with trim and hardware. The number is set by five things:
- Door size and type. A standard 36-inch entry sits at the low end. Oversized, French, or patio entries run $1,800 to $3,400.
- Frame condition. Reusing an existing frame saves $400 to $900. A full frame replacement, common on older hillside homes, adds that cost back and more.
- Wind rating and reinforcement. Impact-rated or wind-rated units add 20% to 30% to the door cost.
- Permit and inspection. If the opening changes or the door is in a rated assembly, expect a permit fee plus inspection scheduling that adds a week or two to the calendar.
- Material grade. Fiberglass and steel land mid-range. Custom wood and premium hardware push toward the top.
A written estimate covers the door unit, labor, trim, sealant, flashing, and haul-away. It typically does not cover structural repair if the rough opening has rot, and it doesn’t cover a new storm door unless you asked for one. We list those separately so the final number doesn’t move. No surprise line items once work starts, and 0% financing for 18 months is available if you’re bundling door work with a larger project.
See the difference
Before
After
Before
After
Before
AfterWhat La Crescenta-Montrose homes specifically do to this job
La Crescenta-Montrose sits against the Verdugo Mountains, and the housing stock shapes this job more than any other factor. The typical home here is a 1940s to 1960s single-family on a sloped lot, and a lot of those homes have additions that were never permitted. When we pull a door frame and find a header that doesn’t match the drawings, that’s a two-week schedule slip and a call to a structural engineer, not a one-day fix. The unincorporated county pockets mean LA County building codes apply, and hillside grading ordinances come into play on anything that touches the slope.
The fire severity zone matters too. Doors on the windward side of a foothill home take more ember exposure and more drying sun than doors on the valley floor. After a heavy rain year, the seasonal debris flow risk on burn scars means the base of a downhill door is the first thing to show water damage. We see sill rot and threshold separation here more than we see it in flat, incorporated cities. And the retaining walls tucked into steep rear yards are a recurring discovery, which is why we always look at the grade before we quote. We are not a 24/7 emergency outfit, but a live person answers the phone around the clock at (844) 797-7958 if you need a quote scheduled.
Serving La Crescenta-Montrose, CA – Our Local Coverage Area
We serve La Crescenta-Montrose and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Door Installation in La Crescenta-Montrose

A single exterior door installs in one to two days once the unit is on site. Order lead time runs two to four weeks, and if the opening needs structural repair, add one to two weeks for engineering review. On hillside homes, we budget three weeks from measurement to finished door. Call (844) 797-7958 to get a real timeline for your address.
You need a permit if the door opening changes size, if it sits in a rated wall assembly, or if it’s part of an addition. A straight replacement in the same opening usually does not require one. Because La Crescenta-Montrose spans unincorporated LA County pockets, we confirm the permit path with the county before we order the door. Call us to walk through your specific door.
Yes, in most homes. Slab replacement keeps the existing frame and moves nothing. If the frame is rotted, full unit replacement is the honest fix, and it still doesn’t require moving wiring or plumbing unless something was run through the jamb. We tell you which path you’re on after the demo, before we order anything.
Exterior door installation runs $650 to $2,400 fully installed, and interior doors run $350 to $900 each. Wind-rated units for the fire severity zone push toward the top of that range. Call (844) 797-7958 for an exact quote – estimates are free and come in writing.
Every door we install is covered by our 730-Day Done Right Promise, one of the longest workmanship guarantees in residential construction. If the seal fails, the swing racks, or the hardware gives out, we make it right. The door manufacturer’s warranty covers the unit itself, and we hand you that paperwork at final walkthrough.
Get a free estimate for your Door Installation in La Crescenta-Montrose
Call (844) 797-7958 for a free on-site estimate. A live person answers around the clock, and we’ll book a time that works for you. On the visit we measure the opening, check the frame and grade, and write out the exact scope and price before you commit. No pressure, no vague bid. If the door work is part of a full Windows & Doors in La Crescenta-Montrose refresh, or you want to pair it with Cabinets & Countertops in La Crescenta-Montrose or a Garage Conversion ADU in La Crescenta-Montrose, we scope it all in one estimate. Our Windows & Doors service covers the wider project, and we work throughout La Crescenta-Montrose and the surrounding foothills.
Written by the team at Groundwork Construction Co.












