







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in South Pasadena, CA: What It Costs and How Long It Takes
A chain link fence in South Pasadena, CA typically runs $3,500 to $9,000 installed, with most residential lots landing between $4,500 and $6,800 depending on linear footage, height, and gate count. A standard 4-foot side or back fence on a typical 6,000-square-foot lot goes up in one to three days. Call (844) 797-7958 for a free on-site estimate and a written line-item quote before any work starts.
How a Chain Link Fence Job Actually Runs, Start to Finish

We schedule a site visit first, measure the run, and check what’s underground before anyone touches a shovel. Here’s the sequence a South Pasadena chain link fence job follows from there.
Stage 1: Site visit and measurements (about 45 minutes)
We walk the property line with you, confirm exactly where you want the fence, and note gates, corners, slopes, and anything buried or overhanging. On older South Pasadena lots this is where we find the surprises – old irrigation lines, tree roots from mature oaks and liquidambars, and the occasional forgotten concrete footing from a fence that came down decades ago. You decide the run and where the gates go at this stage, and we confirm the quote in writing before scheduling.
Stage 2: Utility locating and permit filing (2 to 5 business days)
Before digging, we arrange for underground utilities to be marked. Fences under 7 feet on most residential lots in South Pasadena don’t need a building permit, but taller fences, fences in a front setback, and anything near a corner sight line can trigger review – and the local pro pulls any permit the work requires so the inspection passes. You don’t fill out the paperwork; we do.
Stage 3: Layout and removal of the old fence (half a day)
We string the line, mark post locations at proper spacing (typically 8 to 10 feet on center), and take out the existing fence if there is one. Old wood fencing, rusted chain link, and even the odd remnant of wire-and-post goes into the haul-away. You’re left with a clear, marked line before a single post hole is dug.
Stage 4: Post setting, framing, and fabric (day 2 to day 3)
Posts get set in concrete and need to cure – that’s the one delay nobody can rush. Once they’re solid, we hang top rail and tension wire, roll out fabric, stretch it, and tie it off. Gates get their frames and hardware last. On a straightforward 150-foot run this is a two-day window once the posts are in; a large lot with multiple gates stretches it to three.
Stage 5: Final walk and clean-up
We tension everything, check gate swing and latch alignment, clean up the site, and walk the fence with you before we leave. Anything off, you point it out on the spot. The 730-Day Done Right Promise covers the workmanship – if it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between on a Chain Link Fence
Chain link is a simple system, but the spec choices change both the price and how long the fence looks good in South Pasadena’s sun and clay soil.
- Height and gauge: 4-foot is the residential standard for side and back yards; 5- and 6-foot runs cost more in fabric and posts but hold up better against dogs and wind. Heavier-gauge wire (11.5 vs. 12.5) resists denting and stretching, and it’s the difference between a fence that sags in five years and one that doesn’t.
- Galvanized vs. vinyl-coated: Bare galvanized is the least expensive and perfectly serviceable, but it dulls and stains over time. Vinyl-coated (usually black or green) costs more up front and looks cleaner for years, which matters if the fence faces the street or a patio.
- Post setting: Concrete-set posts are the norm and what we recommend. Drive-in posts are cheaper and faster but shift in expansive foothill clay; a fence near the Arroyo Seco with seasonal soil movement will show it.
- Gates and hardware: Walk gates, double drive gates, and self-closing hinges each add cost. Decide gate count and width at the estimate – adding a gate later means resetting posts.
- Top rail and tension wire: A top rail keeps the fabric from sagging and is worth the small bump in cost. Tension wire at the bottom keeps animals from pushing under.
What a Chain Link Fence Costs in South Pasadena, CA

Plan on $3,500 to $9,000 for a residential chain link fence in South Pasadena. Here’s how that range breaks down and what moves a job toward either end.
- Linear footage: Most South Pasadena lots need 120 to 200 feet of fence. A 120-foot side-and-back run sits near the low end; a full perimeter around a larger Monterey Hills lot pushes past 250 feet and toward the top.
- Height and gauge: Going from 4-foot standard gauge to 6-foot heavier gauge can add 20 to 30 percent to the fabric and post cost.
- Gates: Each walk gate adds a few hundred dollars; a wide double drive gate adds more.
- Site conditions: Slopes, mature tree roots, old footings to remove, and hard clay all add labor. Flat, clear lots are the exception on South Pasadena’s older parcels.
- Finish: Vinyl-coated runs a bit more than bare galvanized for the same footage.
A written estimate from us lists footage, height, gauge, post spacing, gate count, finish, removal of the old fence, and haul-away – line by line, so you see exactly what you’re paying for. If the price is going to change, it changes on paper before we start, not after. What typically isn’t included: landscape repair beyond basic raking, moving irrigation or electrical lines that turn up underground, and anything a utility company needs to relocate.
See the difference
Before
After
Before
After
Before
AfterWhat South Pasadena Homes Specifically Do to This Job
South Pasadena’s housing stock shapes fence work here in ways it doesn’t in most of the San Gabriel Valley. A large share of the homes near Mission and Monterey Hills date to before 1930 – Craftsman bungalows and Spanish Colonial Revival houses often sitting on original lots with mature trees, old irrigation, and decades of accumulated hardscape. When we run a chain link line through a backyard on a street like Diamond Avenue, we’re usually working around oak roots and clay soil that swells and shrinks with the seasons, which is why concrete-set posts matter more here than on newer ground. The city also treats remodeling as stewardship, and while a back-yard chain link fence rarely triggers historic review, fences near a front facade or a property under a Mills Act contract can bring the Cultural Heritage Commission into the conversation – so the local pro confirms what review applies before any permit is filed. In ZIP codes 91030 and 91031, plan for utility locating on every job; the older lines here aren’t always where a plat map says they are. This kind of chain link work is part of the broader Fence Installation in South Pasadena scope we handle, and homeowners often pair this with ADU Site Prep & Utilities in South Pasadena when a new fence line and a backyard build are happening at the same time.
Serving South Pasadena, CA – Our Local Coverage Area
We serve South Pasadena and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in South Pasadena

Most residential chain link fence jobs in South Pasadena take one to three days of on-site work once materials are on hand. Post concrete curing adds a short wait between setting and framing, so a 150-foot run with two gates typically lands in the two- to three-day window. Call (844) 797-7958 for a schedule built around your lot.
In most cases a residential chain link fence under 7 feet on a side or back property line doesn’t require a building permit in South Pasadena. Taller fences, front-yard fences, and corner lots with sight-line rules can require review, so we confirm before digging. The local pro pulls any permit the job requires and handles the inspection. Call for a quick read on your specific lot.
Yes. We route the posts around established trees and existing irrigation rather than cutting through them. On South Pasadena’s older lots we often find irrigation and old footings that need hand-digging, which is a cost and time factor we identify at the estimate, not mid-job. Call for a site walk so we can flag it up front.
Most residential chain link in South Pasadena runs roughly $20 to $40 per linear foot installed, with height, gauge, finish, and gate count driving the number. A full job lands between $3,500 and $9,000. Call (844) 797-7958 for an exact written quote – the estimate is free and the pricing is straightforward.
Workmanship on every chain link fence we install is covered by the 730-Day Done Right Promise – if it’s not done right, we make it right. Material coverage follows the manufacturer’s warranty on fabric, posts, and hardware. Ask about it on the estimate call and we’ll spell out exactly what’s covered.
Get a Free Chain Link Fence Estimate in South Pasadena
Call (844) 797-7958 for a free on-site estimate on your chain link fence in South Pasadena. A live person answers around the clock, and on the call we’ll ask about your property line, footage, gate needs, and timing, then set a site visit. We measure, check the ground, and hand you a written line-item quote – no surprises, no pressure. Our technicians have up to 12 years of experience, and this is part of the full-scope Fence Installation work we handle across South Pasadena. If you’re also replacing an entry or side door while we’re out, homeowners often pair this with Door Installation in South Pasadena.
Written by the team at Groundwork Construction Co.












