







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Pasadena, CA: Cost, Timeline, and What Actually Gets Built
A chain link fence in Pasadena, CA typically runs $3,500 – $9,000 for a residential lot, installed in one to three days depending on linear footage, gate count, and how much old fencing has to come out first. Most single-family properties here land between 100 and 200 linear feet of 4-foot or 6-foot galvanized fencing with one or two gates. Call (844) 797-7958 for a free on-site estimate. A chain link fence is the most honest structure on a property: it either stands straight for decades or it doesn’t, and there’s nowhere to hide a bad post.
From First Stake to Last Tension Band: How a Chain Link Fence Goes In

Forty-foot spacing between posts is a lie you’ll see in cheap bids. A tensioned chain link run needs posts closer than that to hold its shape and stay standing in a Santa Ana wind event. Here’s the sequence we actually run for a chain link fence in Pasadena.
Day 1, morning: walk the line and call 811
We mark the fence line with stakes and string, confirm property boundaries against your plat, and place the 811 utility locate request. That locate is non-negotiable anywhere in Pasadena. Two to three business days later the locates are marked, and that’s when the digging starts. The homeowner decision here is the fence line itself: where it runs, what side of the property line it sits on, and which gate locations actually make sense for daily use versus what looked good on paper.
Day 1 – 2: demo and post setting
Old wood, rusted chain link, broken concrete footings, and stubborn oleander all come out before the new fence goes in. Post holes are dug on a 2-foot schedule, set in concrete, and we leave them to cure overnight. A cured footing is what keeps your fence straight when the soil moves, not a bag of quick-set dumped into a wet hole.
Day 2 – 3: rails, mesh, gates, tension
Top rail slips through the line posts and couples together. Mesh gets stretched with a come-along and tension bands, not by hand, and the bottom edge gets either a tension wire or a bottom rail depending on what you chose. Gate posts get braced horizontally and diagonally so the gate doesn’t sag by year three.
Day 3: gates, hardware, and the walkthrough
Gates hang level, latches catch, and the swing clears the ground. We walk the full run with you, check tension on every bay, and leave the site clean. If you’re planning a gate you’ll use daily, that’s the moment to verify the latch and swing before we load up.
The final inspection
We hand you a walkthrough of the finished fence line, confirm the tension, the gate swing, and the post spacing, and answer every question before you sign off. Nobody’s hiding behind a truck.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices That Actually Decide Whether Your Fence Lasts
Chain link is chain link until you start comparing specs. These are the real forks in the road:
- Galvanized vs. vinyl-coated mesh. Galvanized steel is the workhorse: less expensive, holds up to sun and weather, and lasts decades in most soils. Vinyl-coated (green or black) costs more, cuts glare, and reads softer against a Craftsman bungalow’s landscaping. It also hides the sheen that a plain galvanized fence throws in Pasadena’s summer sun.
- 4-foot vs. 6-foot height. Four feet handles lot-line marking, pet containment, and keeping kids off the street. Six feet gives you real privacy at the pool or along an alley. Height changes the post gauge, the mesh gauge, and the tension demands, so it changes the price.
- Post gauge and mesh gauge. A thinner gauge post costs less and bends sooner. Residential-grade posts and mesh are the right call for most Pasadena lots; heavier gauge earns its money on commercial runs or where kids and dogs hammer the fence.
- Top rail vs. tension wire at the bottom. A bottom tension wire keeps the mesh tight to the ground and stops dogs from pushing through. A bottom rail is sturdier and makes a cleaner line. Tension wire is cheaper and hides the bottom edge; bottom rail looks more finished.
- Gate type and swing. Walk gates and drive gates need braced frames and serious posts. A heavy drive gate on a light post sags within a year. If you plan to hang a drive gate, that decision belongs in the bid, not the afterthought.
- Terminal and corner post bracing. Corners and ends carry the entire tension load of the fence. Brace them properly and the run stays tight. Skip it and the fence pulls away from the first post within a season.
What Chain Link Fence Costs in Pasadena, CA

The lead range for a residential chain link fence in Pasadena is $3,500 – $9,000. That covers most single-family lots at 100 – 200 linear feet with one or two gates, galvanized or vinyl-coated, full demo of existing fencing, and proper footing. A tight corner lot or a clean run with no demo lands at the low end; a large lot with drive gates, heavy herbaceous clearing, and a long run sits at the top.
| Line item | Typical range |
|---|---|
| Galvanized chain link, 4 ft, per linear foot | $18 – $28 |
| Vinyl-coated chain link, 6 ft, per linear foot | $25 – $40 |
| Walk gate (3 – 4 ft) | $250 – $650 |
| Drive gate (10 – 12 ft) | $800 – $2,200 |
| Demo and disposal of existing fence | $400 – $1,400 |
| Post hole concrete and footing work | $15 – $35 per post |
What pushes a job to the high end: a large lot with a long run, a drive gate, heavy brush or old footings to remove, or a footing in tight clay soil that needs a deeper excavation. What keeps it low: a short, straight run with a single walk gate and nothing to tear out. A written estimate spells out post gauge, mesh gauge, rail vs. tension wire, and gate hardware. It does not cover tree removal, concrete replacement along the fence line, or utility relocation, which get quoted separately.
See the difference
Before
After
Before
After
Before
AfterWhat Pasadena Homeowners Greet Us With on Chain Link Fence Jobs
Pasadena’s housing stock shapes this job more than anything else. The city has one of California’s largest concentrations of designated historic districts and landmarks, and its Cultural Heritage Ordinance means external alterations on pre-1940s homes often need a Certificate of Appropriateness before work starts. That matters on a chain link fence because the fence line, gates, and the materials you choose can affect the historic-district review. In Bungalow Heaven and along the Marengo Avenue corridors we regularly see projects that would take two weeks over-the-counter in South Pasadena run months here while the review works through. We build that scheduling reality into every Pasadena chain link fence bid.
The typical chain link job here lands on Craftsman bungalows, Spanish Colonial Revival homes, and period-revival properties from the 1890s – 1930s, with postwar tracts mixed in. Those older properties often mean knob-and-tube wiring, original lath-and-plaster, and unreinforced-masonry details near the fence line, so a locate and a careful dig matter more than on a modern lot. Our technicians have up to 12 years of experience and know exactly where a post hole can and can’t go. The San Gabriel foothills also throw Santa Ana wind events and wildfire-interface pressure at fence lines, so we spec gates and bracing to survive those events, not the calmest week of the year. If your project grows into something bigger, our fence installation service takes the wider view, and homeowners often pair this with ADU Site Prep & Utilities in Pasadena when they’re improving the back lot.
We work across the Pasadena ZIPs 91106, 91105, 91107, and 91104, and we cover neighbors in South Pasadena, San Marino, Altadena, and East San Gabriel too. We use James Hardie-compatible trimming and KraftMaid-grade hardware on gate surrounds where you want the fence line to match the house. Every project is covered by the 730-Day Done Right Promise, and every technician arrives background-checked and uniformed.
Serving Pasadena, CA – Our Local Coverage Area
We serve Pasadena and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Pasadena

Most single-family chain link fence jobs in Pasadena run one to three days on site, with the 811 locate adding two to three business days before we dig. Larger runs with drive gates, heavy clearing, or historic-district review can stretch that timeline. Call (844) 797-7958 for a free estimate that puts a real date on the calendar.
Residential chain link fences in Pasadena usually need a fence permit, and the height limit varies by where the fence sits on the lot, so the front-yard line is stricter than the back. Properties in a historic district or on a landmark may also need review before work starts. We confirm the requirement before we dig. Call (844) 797-7958 and we’ll walk you through what your address needs.
An 811 locate finds utilities first, and the concrete footings go only where the locates say they can. Existing landscaping near the fence line has to be cleared to make room for the post schedule, but we don’t need to disturb plumbing or structure unless the fence line forces it. Call (844) 797-7958 to walk your lot with us before you commit.
Expect $3,500 – $9,000 for a residential chain link fence in Pasadena, with the low end on short, simple runs and the high end on large lots with drive gates and heavy clearing. Per-linear-foot pricing runs $18 – $40 depending on height and coating. Call (844) 797-7958 for a line-item written quote, and estimates are free.
Every chain link fence project is covered by our 730-Day Done Right Promise: if it isn’t done right, we make it right for two full years. Posts, gates, and tension bands are checked at the walkthrough and again if anything shifts. Call (844) 797-7958 to get the estimate rolling.
Get a Free Chain Link Fence Estimate in Pasadena
If you’re ready to price a chain link fence in Pasadena, call (844) 797-7958. A live person answers around the clock, and we’ll schedule a free on-site estimate at your property. You get a written, line-item quote with post gauge, mesh gauge, gate hardware, and demo costs spelled out, so the number you see is the number you pay. No surprises, no vague bids. When your project widens into a full fence line or a door Installation upgrade on the same property, household, or project, we scope it in the same visit.
Written by the team at Groundwork Construction Co.












