







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Burbank, CA: What It Takes and What It Costs
Asphalt driveways and resurfacing in Burbank typically run $3,500 to $9,000 for a full new asphalt pour, with resurfacing (an overlay over sound existing asphalt) landing at the lower half of that range. The work is a two-to-three-day job for most single-family drives: tear-out and grading on day one, base compaction and first lift on day two, finish course and cure time after that. Call (844) 797-7958 and we’ll walk you through what your specific drive actually needs.
How Asphalt Driveways & Resurfacing Get Done, Stage by Stage

The sequence matters more on asphalt than on almost any other driveway material, because a bad base will crack through a perfect surface inside two summers. Here’s how we run it.
Stage 1: Site walk and measurements (day of estimate)
We measure the drive, check slope and drainage away from the garage, and probe the existing base with a spade to see what’s under the asphalt. On older properties we also check whether an unpermitted widening or a converted garage apron is hiding a shallow base. You get a written line-item quote at the end of the visit, not a number scribbled on a card.
Stage 2: Demo and haul-off (half a day to a full day)
Existing asphalt, broken concrete, and any failed base material come out and go to a recycler. This is where surprises surface on Burbank properties: tree roots under a Magnolia Park drive, an old oil-stained gravel layer, or a slab poured directly onto soil with no aggregate base at all. We photograph what we find before it disappears so the quote stays honest.
Stage 3: Grading, base, and compaction (one day)
We cut the grade so water runs to the street or a drainage point instead of pooling at the garage threshold. Then comes 4 to 6 inches of compacted aggregate base, laid in lifts and rolled. You decide at this point whether to add a drainage channel or a trench drain if the drive sits low.
Stage 4: Asphalt placement (one day)
Hot-mix asphalt goes down at 2 to 3 inches compacted for a residential drive, rolled while it’s still workable. Edges get tapered so tires don’t chip them. You’ll pick the finish here: standard dense-graded mix is the default, and a coarser open-graded mix drains faster but costs more.
Stage 5: Cure and sealing schedule (weeks, not days)
Keep cars off for 48 to 72 hours and park heavy vehicles after about a week. Plan to seal the new surface after 6 to 12 months, then every 2 to 3 years after that. We leave you a written cure schedule so nobody parks a boat on it the next morning.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between for Asphalt in Burbank
Asphalt isn’t one product. These are the real forks in the road, with the honest trade-off on each.
- New asphalt pour vs. resurfacing an overlay. A new pour costs more but resets the clock. Resurfacing works only when the base is solid and cracks are hairline; if the base has failed, an overlay is money spent to fail again in three years.
- Dense-graded vs. open-graded mix. Dense-graded is the standard residential mix, smooth and cheaper. Open-graded drains surface water faster, which matters on shaded or low-slope drives, but costs more and needs a slightly thicker section.
- 2-inch vs. 3-inch compacted thickness. Two inches is fine for a car-only drive. Three inches handles an RV, a contractor’s truck, or a household with two heavy SUVs without rutting.
- Standard vs. reinforced base. A geotextile fabric layer under the aggregate base adds cost but fights the root and soil movement we see on older Burbank lots with mature ficus and liquidambar.
- Sealer: asphalt-emulsion vs. coal-tar. Emulsion sealers are the current default; they cure fast and are easier to maintain. Coal-tar lasts longer per coat but is being phased out in many markets and is harder to source.
Homeowners often pair a new drive with Chain Link Fence in Burbank along the property line, since the demo phase is the cheapest time to set posts.
What Asphalt Driveways & Resurfacing Costs in Burbank, CA

Expect $3,500 to $9,000 for asphalt driveway paving in Burbank, and plan separately for sealing at $250 to $700 a few months after the new surface cures. Here’s what pushes a job toward either end of that range.
| Line item | Typical range |
|---|---|
| New asphalt driveway paving | $3,500 – $9,000 |
| Full driveway replacement (demo + new) | $5,000 – $14,000 |
| Driveway sealing (maintenance coat) | $250 – $700 |
The four or five variables that actually move the number:
- Square footage and access. A 400-square-foot single-car apron is a half-day pour. A 900-square-foot drive with a narrow side-yard gate slows the haul-off and adds labor.
- Condition of the existing base. A drive that’s already failed to the subgrade means full demo and new aggregate, which lands you in replacement territory rather than resurfacing.
- Drainage work. A trench drain, a channel drain, or a regrade to move water off the Verdugo-facing slope adds cost but prevents the pooling that eats asphalt edges.
- Thickness and mix grade. Stepping up to a 3-inch section or an open-graded mix adds materially to the per-square-foot price.
- Permit scope. A like-for-like replacement often doesn’t trigger a separate grading permit. Widening the drive or changing the curb cut does, and that’s a real cost.
A written estimate should list demo, haul-off, base depth, asphalt thickness, compaction, and cleanup line by line, with the price locked. What it typically doesn’t include: drainage fixtures unless specified, tree-root removal, and the first sealing coat months later. Ask for those as separate lines so nothing gets surprised onto the invoice.
See the difference
Before
After
Before
After
Before
AfterWhat Burbank Homes Specifically Do to This Job
Burbank’s housing stock shapes asphalt work in ways a generic driveway page won’t tell you. In Magnolia Park and the Rancho Equestrian district, the 1920s-to-1940s bungalows often sit behind a drive that was widened informally decades ago, sometimes over an old gravel or brick apron, and that shallow base shows up the moment we probe it. The dry San Fernando Valley heat bakes unshaded asphalt quickly, and the Santa Ana wind events push grit and debris across exposed surfaces, so an unsealed drive in Burbank chalks and grays faster than a drive in a cooler coastal city. The winter rain we do get runs hard off the Verdugo foothills, which is why drainage away from the garage threshold matters more on hillside streets than on flatland ones. We also see the converted-garage pattern common to this era of Burbank housing, where the drive was never sized for the traffic the property now generates. If your asphalt job is part of a full Driveway & Pavers in Burbank plan, we’ll scope the whole thing at once.
Serving Burbank, CA – Our Local Coverage Area
We serve Burbank and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Asphalt Driveways & Resurfacing in Burbank

Most asphalt driveways and resurfacing jobs in Burbank finish in two to three working days, with a 48-to-72-hour no-drive window after the final lift. Resurfacing over a sound base can be a single day because there’s no demo and no new aggregate. Call (844) 797-7958 for a timeline on your specific drive.
Often not for a like-for-like replacement, but widening the drive, changing the curb cut, or altering drainage typically does require a permit and inspection. The local pro pulls what’s required and passes the inspection before we call the job done. Call (844) 797-7958 and we’ll tell you which category your project lands in.
Yes, when the base is sound and the cracking is hairline rather than structural. If the asphalt has settled, rutted, or failed to the subgrade, an overlay is temporary at best, and replacement is the honest recommendation. Call (844) 797-7958 for a free on-site check that tells you which one you actually need.
Resurfacing usually runs below the $3,500 – $9,000 new-paving range because it skips demo and base work, while a full driveway replacement in Burbank lands between $5,000 and $14,000. The delta comes down to base condition. Call (844) 797-7958 for an exact quote.
Every asphalt job we complete is backed by our 730-Day Done Right Promise: if the workmanship isn’t right, we make it right. That covers installation defects, not damage from tree roots, heavy equipment, or skipped sealing. Call (844) 797-7958 to confirm what’s covered on your project.
Get a Free On-Site Asphalt Estimate in Burbank
Call (844) 797-7958 for a free estimate on asphalt driveways and resurfacing in Burbank. A live person answers around the clock, so you won’t sit in a voicemail queue. On the call we book a site visit, measure the drive, probe the base, and hand you a written line-item quote with the price locked. If your project ties into a broader Driveway & Pavers scope or a ADU Site Prep & Utilities in Burbank build, we’ll scope both together. We cover all of Burbank and the surrounding valley.
Written by the team at Groundwork Construction Co.












